» » Power Amplifier 4 Transistor

Power Amplifier 4 Transistor

Thursday, April 5, 2012 by skemarangkaian

Power Amplifier 4 Transistor
Above diagram very simple and easy to build class AB audio amplifier circuit which is working with 4 transistors. In class AB operation each output device performs more than half of the input signal cycle. Up to 78% effectiveness is possible with class AB designs and cross over distortion is minimized. The circuit shown here is appropriate for small radio receivers, audio players, intercom, phone etc.

Transistor Q1 with its connected parts is wired as a pre-amplifier stage. The audio input is coupled to the base of Q1 through resistor R1 and capacitor C1. Resistor R3 delivers collector to base bias for Q1 and C3 is an AC by pass capacitor for the collector resistor R4. Collector to base biasing is a great method of biasing for circuits like this because it provides enough negative feedback, prevents thermal runway and stabilizes the operating point. The second stage will be the driver stage for the push pull pair. Q2 with its connected parts carry out this job. This stage can also be collector to base biased, and its input is coupled towards the output from the pre-amplifier stage using capacitor C2. Resistor R8 limits the collector present of Q2.The third stage is the class AB push pull section comprising of transistors Q3 and Q4. Diodes D1 and D2 provides the bias voltage for the push pull stage. The output from the amplifier is coupled to the loud speaker through the capacitor C4. C5 and C6 are power supply filter capacitors.
Notes:
  1. The circuit can be assembled on a vero board.
  2. K1 may be an 8 ohm/5Wof loud speaker.
  3. C6 must be grounded near towards the Q1 and C5 should be grounded near to the loud speaker ground. This reduces noise.
  4. Use 5V DC power supply for powering the circuit.

Posted in: | | |  

Bookmark and Share